SANSE can design and manufacture motors specific to your environmental, mec

hanical, and dimensional requirements.
Clean Room Environment
Stainless Steel
Anodize Finish
Assembly Integration

NEMA 11, 1.8 degree Motor
Up to 16 oz-in holding torque
Vacuum Ratings from 10 Torr to 10Torr

The vacuum rated motor measures a mere 1.1” square and is available in three lengths: the 211-13 is 1.24”, the 211-18 is 1.75” and the 211-20 is 1.99.” In order to make these small but powerful motors vacuum rated, Lin Engineering ensures that all of the special handling and parts necessary are used in the manufacturing process. First of all, all paint and oils are removed from the motor. Next, high temperature windings are utilized as well as Teflon leads. Lastly, depending on the rating of the vacuum environment, either no-lube stainless steel bearings or special-lube stainless steel bearings are used. During the entire manufacturing process, latex gloves are worn to ensure that no residue from human touch is left behind on the motors. All of the above special parts and handling ensure that limited outgassing and contamination will occur.

NEMA 17 and 23 vacuum motors are also available, please contact Lin Engineering for more information.
Note: click here motor specifications.

The IP65 Series of motors are totally protected against dust as well as guaranteed to withstand low pressure jets of water sprayed from all directions from a distance of 3 meters. These jets of water can carry pressure of up to 30 kPa from all directions at a rate of 12.5 l/min for the duration of 3 minutes. In addition to being protected from environmental factors, the coating on our IP65 Series motors is also FDA approved.

For smaller or larger IP65 motor, please contact sales@linengineering.com or call (408) 919-0200

The IPX7 series of motors are completely protected against dust; they are also made to withstand immersion into liquids in depths of 15cm to 1m for time periods of up to 30 minutes. ??In addition to being protected from environmental factors, the coating on our IPX7 Series motors is also FDA approved.? The Lin Engineering 5718 series step motors are now available with an IPX7 rating.? The 5718 is a 1.8, NEMA size 23 stepper motor that has a MAX body length of 2.25”.? This motor is available in three stack lengths is capable of producing holding torque up to 294 oz-in.? Unipolar and bipolar windings are available to allow for the torque and speed required to accommodate your application.

For smaller or larger IPX7 rated motors, please contact sales@linengineering.com
or call (408) 919-0200.